Parameter Reduction of Composite Load Model Using Active Subspace Method

Zixiao Ma

doi:10.1109/TPWRS.2021.3078671

Return

Parameter Reduction of Composite Load Model Using Active Subspace Method

2021-11-01

DOI：10.1109/TPWRS.2021.3078671

Original

Original request for help

Save

Abstract

En 中文

Over the past decades, the increasing penetration of distributed energy resources (DERs) has dramatically changed the power load composition in the distribution networks. The traditional static and dynamic load models can hardly capture the dynamic behavior of modern loads especially for fault-induced delayed voltage recovery (FIDVR) events. Thus, a more comprehensive composite load model with combination of static load, different types of induction motors, single-phase A/C motor, electronic load and DERs has been proposed by Western Electricity Coordinating Council (WECC). However, due to the large number of parameters and model complexity, the WECC composite load model (WECC CMLD) raises new challenges to power system studies. To overcome these challenges, in this paper, a cutting-edge parameter reduction (PR) approach for WECC CMLD based on active subspace method (ASM) is proposed. Firstly, the WECC CMLD is parameterized in a discrete-time manner for the application of the proposed method. Then, parameter sensitivities are calculated by discovering the active subspace, which is a lower-dimensional linear subspace of the parameter space of WECC CMLD in which the dynamic response is most sensitive. The interdependency among parameters can be taken into consideration by our approach. Finally, the numerical experiments validate the effectiveness and advantages of the proposed approach for WECC CMLD model.

Keywords:

Load modeling

Induction motors

Sensitivity

Power system dynamics

Computational modeling

Optimization

Open area test sites

WECC composite load model

parameter reduction

active subspace

dimension reduction