Three-dimensional compressor blading design improvements in low-speed model testing

doi:10.1016/j.ast.2016.12.033

Three-dimensional compressor blading design improvements in low-speed model testing

2017-04-01

22

PRE

AI

DOI：10.1016/j.ast.2016.12.033

Original

Original request for help

Save

Abstract

En 中文

Low-speed model testing (LSMT) plays a key role in multistage axial-compressor design due to that utilizations of low-speed large-scale compressor to perform three-dimensional (3D) blading design are fast, convenient and cost-saving. This paper mainly focuses on numerical investigations of 3D blading improvements for LSMT with several design techniques. Firstly, numerical method is verified with existed experimental data. Then, revised techniques for both of the rotor and stator are presented, involving circumferential stacking principles, compressor blade row matching, loaded leading edge (LE) and unloaded trailing edge (TE), and bowed stator technology, et al. The flow mechanisms for these techniques are briefly discussed. The final revised scheme for the model stage (the 3rd stage) is determined with abovementioned methods. Flow loss near the hub are largely alleviated for the revised stage, the efficiency for the model stage and corresponding compressor are raised by 2.2% and 0.5% at design point, while stable operating range is slightly widen. (C) 2017 Elsevier Masson SAS. All rights reserved.

Keywords:

Axial flow compressors

Low-speed model testing

Blading improvement

3D stacking

Loaded LE

Unloaded TE

Three-dimensional compressor blading design improvements in low-speed model testing

Abstract

AI Summary

Journal

Organization