.png){kind=icon}
.png){kind=icon}
Return
Transient heat transfer characteristics in an electrically heated continuous steel-strip annealing furnace
.png){kind=icon}
PRE
AI
J
C
L
DOI：10.1007/s12206-026-0264-3.png)
.png){kind=icon}
Original request for help.png){kind=icon}
Share.png){kind=icon}
Save
Abstract
En 中文
This work applies a previously validated 3-D transient CFD model to elucidate radiation-dominated heat transfer in an electrically heated continuous annealing furnace during strip charging. The six heater furnace is simulated using a coupled electro-thermal framework with surface-to-surface radiation and temperature-dependent emissivity. Immediately after entry, buoyancy-driven natural convection intensifies, raising peak sectional velocities up to 2.2 & times; over the no-load state. The openings preheat the lateral faces yet introduce localized losses; due to view factor advantages, the side faces heat earlier than the top/bottom surfaces. Heat flux decomposition shows that similar to 98 % of the net radiative input converts to conduction in the strip. Varying strip width (50-150 mm) markedly reshapes the radiative field and widthwise uniformity. The findings identify opening design, heater placement/spacing, and edge-compensated power distribution as primary levers for achieving target temperature and uniformity.
Keywords:
Strip annealing
Continuous furnace
Electrification
Heat transfer
Thermal characteristics
Journal
IF:
1.7
Papers:
481
Citations:
1.2W
Organization
Cited Papers