Sallal R. Abid - Publications, H-index & Citations

Sallal R. Abid

Wasit University

31H指数

112论文数

2.9K被引数

收录论文 60

发表时间

Flexural performance of low-cost lightweight low-bearing sandwich panels with minimal shear reinforcement 低成本低承重夹层板在最小剪力加固下的弯曲性能

Results in Engineering

IF7.9

2026-04-26

OAAI

Omar M.H. Chlaibawi; Sallal R. Abid; G. Murali; Khaldoon S.A. Altameemi

Assessing the influence of void and thermal interactions on the mechanical performance of self-compacting concrete under elevated temperature 评估孔隙和热相互作用对高温下自密实混凝土力学性能的影响

Scientific Reports

IF3.9

2026-04-22

OAAI

G. Murali; Sallal R. Abid; Raad A. Al-Ameri; Ahmmad A. Abbass; Sajjad H. Ali; Marzena Kurpińska; Hakim S. Abdelgader

Experimental evaluation and reliability analysis of void configuration effect on the compressive strength of self-compacting concrete exposed to elevated temperatures 自密实混凝土在高温暴露条件下，孔隙结构配置效应对其抗压强度影响的实验评估与可靠性分析

Case Studies in Construction Materials

IF6.6

2025-09-01

OAAI

Sallal R. Abid; G. Murali; Raad A. Al-Ameri; Ahmmad A. Abbass; Sajjad H. Ali

Effect of notch configurations on impact response of engineering cementitious composites 缺口配置对工程水泥基复合材料冲击响应的影响

Archives of Civil and Mechanical Engineering

IF4.4

2025-07-15

PREAI

Sallal R. Abid; G. Murali; Ahmmad A. Abbass; Sajjad H. Ali

Comprehensive analysis of pre-crack parameters on repeated impact strength and failure mechanism: Effects of crack depth, length, and position in engineering cementitious composites 预裂纹参数对重复冲击强度和失效机理的综合分析：工程水泥基复合材料中裂纹深度、长度和位置的影响

CONSTRUCTION AND BUILDING MATERIALS

IF8

2025-06-01

PREAI

Abid, Sallal R.; Murali, G.; Ali, Sajjad H.

Impact of various fibers on mode I, III and I/III fracture toughness in slag, fly Ash, and silica fume-based geopolymer concrete using edge-notched disc bend specimen 使用边缘缺口圆盘弯曲试样，各种纤维对矿渣，粉煤灰和硅粉基地质聚合物混凝土中I，III和I/III型断裂韧性的影响

THEORETICAL AND APPLIED FRACTURE MECHANICS

IF5.6

2024-12-01

PREAI

Karthik, S.; Mohan, K. Saravana Raja; Murali, G.; Abid, Sallal R.; Dixit, Saurav

Heat endurance and impact resistance: Investigating fibrous engineered cementitious composites under impact loads at elevated temperatures

CASE STUDIES IN CONSTRUCTION MATERIALS

IF6.6

2024-12-01

OAAI

Abid, Sallal R.; Al-Ameri, Raad A.; Murali, G.; Ali, Sajjad H.; Ozakca, Mustafa

Harnessing waste for sustainable construction: A novel synthesizing activators from waste for one-part geopolymer concrete and evaluating its fracture toughness

THEORETICAL AND APPLIED FRACTURE MECHANICS

IF5.6

2024-12-01

PREAI

Murali, G.; Nassar, Anoop Kallamalayil; Kathirvel, Parthiban; Wong, Leong Sing; Karthikeyan, K.; Abid, Sallal R.

Impact response of cementitious composites incorporating waste glass and untreated PVA fibers

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T

IF6.6

2024-11-01

OAAI

Abid, Sallal R.; Mhalhal, Jasim A.; Murali, G.; Kadhum, Ahmed L.; Ali, Sajjad H.

A comprehensive review of drop weight impact testing: Evaluating the Pros and Cons in fiber-reinforced concrete performance assessment

JOURNAL OF BUILDING ENGINEERING

IF7.4

2024-10-01

PREAI

Murali, G.; Wong, Leong Sing; Abid, Sallal R.

Synergistic effects of graphene oxide, steel wire mesh and fibers on the impact resistance of preplaced aggregate concrete

JOURNAL OF BUILDING ENGINEERING

IF7.4

2024-10-01

PREAI

Murali, G.; Karthikeyan, K.; Senthilpandian, M.; Wong, Leong Sing; Abid, Sallal R.; Kumar, Manth

From waste to resource recycled lime sludge: Sustainable low clinker cementitious binder, a comprehensive study on hydration, strength of concrete

JOURNAL OF BUILDING ENGINEERING

IF7.4

2024-06-01

PREAI

Murali, G.; Wong, Leong Sing; Ramkumar, V. R.; Abid, Sallal R.; Karthik, S.

Enhanced impact properties of functionally graded preplaced aggregate fibrous concrete slabs comprising alkali-activated slag and carbon nanotube grout

JOURNAL OF BUILDING ENGINEERING

IF7.4

2024-04-01

PREAI

Murali, G.; Parthiban, K.; Wong, Leong Sing; Abid, Sallal R.; Nassar, Anoop Kallamalayil

Flexural behavior of cold-formed U-shaped steel members encasing concrete composite beam using continues stud bolts

STRUCTURAL CONCRETE

IF3.3

2024-01-24

PREAI

Al-Lami, Karrar; Jabir, Hussain A.; Shamsaldeen, Hassan A.; Algasham, Thaar; Mhalhal, Jasim M.; Goaiz, Hussam A.; Abid, Sallal

Response of treated recycled aggregate concrete against low-velocity impact loading: Experimental and Weibull statistical analysis

CONSTRUCTION AND BUILDING MATERIALS

IF8

2023-12-01

PREAI

Murali, G.; Katman, Herda Yati Binti; Wong, Leong Sing; Ibrahim, Mohd Rasdan; Kathirvel, Parthiban; Abid, Sallal R.

Effect of recycled lime sludge, calcined clay and silica fume blended binder-based fibrous concrete with superior impact strength and fracture toughness

CONSTRUCTION AND BUILDING MATERIALS

IF8

2023-12-01

PREAI

Murali, G.; Katman, Herda Yati Binti; Wong, Leong Sing; Ibrahim, Mohd Rasdan; Ramkumar, V. R.; Abid, Sallal R.

Thermal Behaviour and Microstructure of Self-Cured High-Strength Plain and Fibrous Geopolymer Concrete Exposed to Various Fire Scenarios

BUILDINGS

IF3.1

2023-09-26

OAAI

Ali, Hayder Khalid; Abid, Sallal R.; Taysi, Nildem

Underwater surface abrasion of conventional and geopolymer concrete using the ASTM C1138 approach

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T

IF6.6

2023-07-01

OAAI

Abdulhassan, Noor A.; Hilo, Ali N.; Abid, Sallal R.; Al-Ghasham, Thaar S.; Cheyad, Shams M.

Mechanical Properties of Engineered Cementitious Composites with Low Cost Fibers and Recycled Glass Filler

SUSTAINABILITY

IF3.3

2023-06-22

OAAI

Abid, Sallal R.; Nahhab, Ali H.; Al-Dahawi, Ali M.; Kadhum, Ahmed L.; Ali, Sajjad H.

Flexural performance of concrete beams internally reinforced with steel, geogrid and GFRP meshes

JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T

IF6.6

2023-05-01

OAAI

Hanan, Aliaa K.; Muttashar, Majid D.; Abid, Sallal R.; Yosri, Ahmed M.; Alsharari, Fahad; Deifalla, Ahmed Farouk

研究方向