arrow
返回

A General Switch-Mode Amplifier Design for Actuators Using MIMO Optimal Feedback Quantization

delete2009-12-01
delete4
PRE
AI
J
Jwu‐Sheng Hu *
DOI:10.1109/TIE.2009.2027578delete
delete原文链接
delete原文求助
delete分享
delete收藏
摘要

摘要

En 中文
This paper proposes a novel switch-mode power stage architecture for actuators. For a large number of actuators, the associated power amplifier becomes costly and bulky when each actuator is controlled by an independent amplifier. The proposed architecture allows actuators to share power amplifiers, thereby reducing the number of switching devices. This architecture is mapped into the graph theorem, and acceptable actuation states are analyzed. The switching method is controlled by multiple-input multiple-output optimal feedback quantization, which is designed to minimize a weighted measure of quantization distortion. Simulation and experimental results illustrate the effectiveness of the proposed scheme.
Keyword:
Multiple-input multiple-output (MIMO) systems
optimal control
quantization
switching amplifier
AI总结

AI总结

对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。

期刊

IEEE Transactions on Industrial Electronics 封面图
IEEE Transactions on Industrial Electronics
IF:
7.2
论文数:
1.8W
被引数:
9.8W

机构

N
National Yang Ming Chiao Tung University
学者数:
2.5W
论文数: 2.3W
被引数: 2.2W
引用论文

引用论文

err分享
err收藏
Gas detection using an integrating sphere as a multipass absorption cell
err2006-10-18
err0
PREAI
errEamonn Hawe; Gerard Dooly; Paul Chambers; Colin Fitzpatrick; Elfed Lewis
err分享
err收藏
学者 查看更多内容