.png){kind=icon}
返回
A Shape-Morphing Ceramic Composite for Variable Geometry Scramjet Inlets
.png){kind=icon}
PRE
AI
DOI：10.1111/j.1551-2916.2011.04561.x.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
The development of ceramic composites with three-dimensional fiber reinforcement architectures formed by textile methods has led to the potential for active shape-morphing surfaces that can operate in high temperature and variable pressure environments. This technology is of particular interest for hypersonic applications, where SCRAM jet engines require variable inlet geometry to achieve efficient flight over realistic flight profiles and variable flight conditions. The experiments reported here show that significant shape morphing can be achieved and good control of the shape sustained even in the presence of large temperature and pressure gradients. Experiments were carried out using a subscale morphing hypersonic inlet with rectangular cross-section in a Mach 8 wind tunnel facility with a total temperature of 800 K. The upper surface of the inlet consisted of a C-SiC composite plate (0.7 mm thick, 37.5 cm long, and 11 cm wide) connected to five actuators through a triangular truss support structure. The lower surface was a flat plate instrumented with an array of pressure taps along the flow centerline. As the shape varied, the surface contour was reliably controlled for high efficiency, low loss compression. A factor of six inlet area ratio variation was achieved and good agreement with model predictions was observed.
Keyword:
TEMPERATURE FATIGUE
DESIGN
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3.8
论文数:
1.7W
被引数:
5.4W
机构
引用论文
.png){kind=icon}
分享收藏Treating matrix nonlinearity in the binary model formulation for 3D ceramic composite structures
PREAI
分享收藏
查看更多内容