.png){kind=icon}
.png){kind=icon}
返回
Accurate error compensation method for multi-axis parallel machine via singularized jacobi geometric parameter correction and coupling error evaluation
.png){kind=icon}
PRE
AI
DOI：10.1016/j.rcim.2024.102771.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
The Jacobian model is a prevalent tool for error compensation in multi-axis parallel mechanisms. However, discrepancies between the model's nominal and actual geometrical parameters, combined with equivalent replacements and high-order rounding in the modeling process, lead to equation solving challenges and modeling errors. These inaccuracies result in residual errors in the Jacobian model compensation. To address these problems, this paper proposes an optimal Jacobian correction approach. This is based on a geometrical parameter singularized Jacobian correction model, and a module for the evaluation of coupling errors for multiaxis parallel mechanisms was incorporated. Instead of relying on iterative processes, a singularized geometrical error solution method (SESM) was developed. Through this method, precise derivation of the Jacobian correction parameters is ensured, effectively addressing the indefinite equation challenge and partial posture non-solution problem. Moreover, modeling errors resulting from equivalent infinitesimal replacements and the overlooking of high-order minor values are compensated for by the SESM. It was observed that varying singularized geometrical parameters in the Jacobian model can produce different coupling effects and compensation outcomes. Therefore, a sensitivity-based error predictive evaluation method (EPEM) was introduced. By this method, the optimal correction parameter of the Jacobian model across the entire workspace is identified, ensuring precise pose error compensation. The proposed method was validated using a three-axis parallel mechanism. Through these tests, its superior efficacy was revealed. In comparison to the traditional uncorrected Jacobian compensation, reductions in position and orientation errors by 64.93% and 55.29%, respectively, were achieved. This method provides a new approach for error modeling, equation solving, and parameter correction for multi-axis mechanism error compensation and precision equipment development.
Keyword:
Multi-axis parallel mechanism
Error compensation
Singularized geometrical error
Coupling effect
Error predictive evaluation
期刊
R
IF:
11.4
论文数:
3.3K
被引数:
1.3W