.png){kind=icon}
返回
Efficient numerical-control simulation for multi-axis machining based on three-level grids
.png){kind=icon}
PRE
AI
DOI：10.1007/s40436-024-00539-4.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
This paper presents an accurate and efficient method for computing machined part geometry and determining cutter-workpiece engagement (CWE) in multi-axis milling. The proposed method is based on volumetric models, with three types of three-level data structures proposed to represent a solid workpiece voxel model for a sparse and memory-efficient implementation. At each cutter location, every coarse workpiece voxel is efficiently updated from the top to the lower level, and the vertex states and edge intersection points inside each bottom-level voxel crossed by the cutter envelope surface continue to be updated using the dynamic marching cube algorithm. Meanwhile, the finest intersecting voxels are projected onto the cutter surface such that the projected engagement patches connect to form the required engagement map. Finally, according to the lookup table, a triangular mesh of the machined part is built by reconstructing and fusing the approximation polygons inside the bottom-level workpiece surface voxels. Quantitative comparisons of the proposed method against the two-level grid and the tri-dexel model demonstrated the high accuracy and considerable ability of the proposed method to provide more significant and stable efficiency improvement without being affected by a large branching factor owing to its more efficient spatial partitioning.
Keyword:
Machining simulation
Voxel
Three-level grid
Workpiece update
Cutter-workpiece engagement (CWE)
期刊
IF:
3.8
论文数:
604
被引数:
1.9K
机构
引用论文
.png){kind=icon}
分享收藏Removal of Hg(II) ions with CD/DVD waste-derived aminated polycarbonate: adsorption and optimization studies利用由CD/DVD废料制备的氨基化聚碳酸酯去除Hg(II)离子：吸附与优化研究
PREAI
分享收藏分享收藏
查看更多内容