arrow
返回

Fault detection based on Kernel Principal Component Analysis

delete2010-11-01
delete147
PRE
AI
V
Viet Ha Nguyen *
J
Jean‐Claude Golinval
DOI:10.1016/j.engstruct.2010.08.012delete
delete原文链接
delete原文求助
delete分享
delete收藏
摘要

摘要

En 中文
In the field of structural health monitoring or machine condition monitoring, the activation of nonlinear dynamic behavior may render the procedure of damage or fault detection more difficult. Principal Component Analysis (PCA) is known as a popular method for diagnosis but as it is basically a linear method, it may pass over some useful nonlinear features of the system behavior. One possible extension of PCA is Kernel PCA (KPCA), owing to the use of nonlinear kernel functions that allow introduction of nonlinear dependences between variables. The objective of this paper is to address the problem of fault detection (in terms of nonlinear activation) in mechanical systems using a KPCA-based method. The detection is achieved by comparing the subspaces between the reference and a current state of the system through the concept of subspace angle. It is shown in this work that the exploitation of the measurements in the form of block Hankel matrices can effectively improve the detection results. The method is illustrated on an experimental example consisting of a beam with a geometric nonlinearity. (C) 2010 Elsevier Ltd. All rights reserved.
Keyword:
PCA
KPCA
Subspace
Nonlinearity
Detection
AI总结

AI总结

对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。

期刊

Engineering Structures 封面图
Engineering Structures
IF:
6.4
论文数:
2.1W
被引数:
8.7W

机构

U
University of Liege
学者数:
1.7W
论文数: 1.4W
被引数: 2.1W
引用论文

引用论文

err分享
err收藏
Nonlinear process monitoring using kernel principal component analysis
err2004-01-01
err1.0K
PREAI
errLee, JM; Yoo, CK; Choi, SW; Vanrolleghem, PA; Lee, IB
err分享
err收藏
学者 查看更多内容