.png){kind=icon}
返回
Monte-Carlo simulation and performance optimization for the cathode microstructure in a solid oxide fuel cell
.png){kind=icon}
PRE
AI
DOI：10.1016/j.jpowsour.2006.12.058.png)
.png){kind=icon}
原文求助.png){kind=icon}
分享.png){kind=icon}
收藏
摘要
En 中文
A 3D micro-scale model is developed to simulate the transport and electrochemical reaction in a composite cathode. This model takes into account the details of the specific cathode microstructure such as random pore structure, active TPB (three phase boundary) site distribution, particle size and composition and their interrelationship to the charge transfer and mass transport processes. Especially, the pore structure and mass diffusion were incorporated into this model. Influence of the microsturcture parameters on the performance was investigated by numerical simulations. Simulation shows that the cathode porosity should be in the range of 0.25-0.45 for the optimized performance. A larger thickness is in favor of increasing the effective reaction sites and reducing total specific resistance. However, the thickness needs to be confined below a certain thickness in order to prevent lower utilization and excessive concentration loss. The fine particles contribute to increase the TPB length and thus decrease the activation overpotential. On the other hand, the extremely small particles might lead to an excessive diffusion resistance. The model was validated based on the continuum model and experimental data to determine its accuracy in predicting the cathode performance. The results generally agree with the experimental data from the literature. However, as compared with the continuum model, the predicted total resistance is slightly higher for a thin electrode. (c) 2007 Elsevier B.V. All rights reserved.
Keyword:
solid oxide fuel cell
composite electrode
optimization
modeling
AI总结
对已上传原文的论文进行重点信息的提取，主要内容包括：简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
7.9
论文数:
3.7W
被引数:
15.0W
机构
暂无机构信息
引用论文
Effects of transport scale on heat/mass transfer and performance optimization for solid oxide fuel cells输运尺度对固体氧化物燃料电池传热/传质的影响及性能优化
PREAI
分享收藏
Microstructural optimization of anode-supported solid oxide fuel cells by a comprehensive microscale model通过综合的微尺度模型优化阳极支撑的固体氧化物燃料电池的微观结构
PREAI
分享收藏Value Stream Mapping: a study about the problems and challenges found in the literature from the past 15 years about application of Lean tools价值流程图: 关于过去15年文献中关于精益工具应用的问题和挑战的研究
PREAI
分享收藏分享收藏Simulation of a composite cathode in solid oxide fuel cells固体氧化物燃料电池中复合阴极的模拟.png)
ELECTROCHIMICA ACTA
ELECTROCHIMICA ACTAIF5.6
PREAI
分享收藏
查看更多内容