返回
Interface engineered HfO2-based 3D vertical ReRAM
DOI:10.1088/0022-3727/49/21/215102.png)
摘要
En 中文
We demonstrate a double-layer 3D vertical resistive random access memory (ReRAM) stack implementing a Pt/HfO2/TiN memory cell. The HfO2 switching layer is grown by atomic layer deposition on the sidewall of a SiO2/TiN/SiO2/TiN/SiO2 multilayer pillar. A steep vertical profile was achieved using CMOS-compatible TiN dry etching. We employ in situ TiN bottom interface engineering by ozone, which results in (a) significant forming voltage reduction which allows for forming-free operation in AC pulsed mode, and (b) non-linearity tuning of low resistance state by current compliance during Set operation. The vertical ReRAM shows excellent read and write disturb immunity between vertically stacked cells, retention over 10(4) s and excellent switching stability at 400 K. Endurance of 10(7) write cycles was achieved using 100 ns wide AC pulses while fast switching speed using pulses of only 10 ns width is also demonstrated. The active switching region was evaluated to be located closer to the bottom interface which allows for the observed high endurance.
Keyword:
ReRAM
V-RRAM
resistive-switching
HfO2
TiON
ozone
filament
AI总结
对已上传原文的论文进行重点信息的提取,主要内容包括:简要概述、研究摘要、背景介绍、关键亮点、图文解析、展望与总结。
期刊
IF:
3.2
论文数:
2.6W
被引数:
4.9W
机构
引用论文
Redox-Based Resistive Switching Memories - Nanoionic Mechanisms, Prospects, and Challenges基于氧化还原的电阻开关存储器-纳米离子机制,前景和挑战
ADVANCED MATERIALS
IF26.8
HfOx-Based Vertical Resistive Switching Random Access Memory Suitable for Bit-Cost-Effective Three-Dimensional Cross-Point Architecture
ACS NANO
IF16

