Antonio Andreini - Publications, H-index & Citations

Antonio Andreini

university of florence

23H指数

332论文数

2.4K被引数

收录论文 27

发表时间

A hybrid multiphase model for simulating condensing gravity-driven flows 用于模拟冷凝重力驱动流的混合多相模型

Applied Thermal Engineering

IF6.9

2026-09-17

OAAI

I. Rafanelli; N. Andreini; A. Andreini

Wall Condensation in Steam Turbine Startups: Preliminary Design Assessments 蒸汽轮机启动过程中的壁面凝结：初步设计评估

Journal of Engineering for Gas Turbines and Power-Transactions of the ASME

IF2.1

2026-03-01

PREAI

Rafanelli, Isacco; Andreini, Antonio; Facchini, Bruno; Diurno, Tommaso; Tomasello, Stella Grazia

Design and Numerical Investigation of a Swirl-Stabilized Hydrogen Burner for Aero Engine Applications 航空发动机应用中旋流稳定氢燃烧器的设计与数值研究

Journal of Engineering for Gas Turbines and Power-Transactions of the ASME

IF2.1

2026-01-01

PREAI

Ballotti, A.; Senatori, G.; Galeotti, S.; Andreini, A.

The Control of Hydrogen-Air Ignition Dynamics to Prevent Flashback 氢-空气点火动力学控制以防止回火

Journal of Engineering for Gas Turbines and Power-Transactions of the ASME

IF2.1

2026-01-01

PREAI

Amerighi, M.; Senatori, G.; Andreini, A.

Loosely-coupled Conjugate Heat Transfer analysis of transient wall condensation 松散耦合的共轭传热分析瞬态壁面冷凝

International Journal of Thermal Sciences

IF5

2025-11-25

OAAI

I. Rafanelli; A. Andreini; L. He

LES analysis of the DLR F400S.3 mGT burner operating with 100% hydrogen fuel 对DLR F400S.3 mGT燃烧器使用100%氢燃料的大涡模拟分析

International Journal of Hydrogen Energy

IF8.3

2025-10-20

OAAI

G. Generini; M. Amerighi; T. Lingstädt; P. Kutne; A. Andreini

Large Eddy Simulation Investigation of Film Cooling in Rotating Detonation Combustors 旋转爆震燃烧器中薄膜冷却的大涡模拟研究

JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME

IF3.1

2025-10-01

PREAI

Ramanagar-Sridhara, S.; Andreini, Antonio; Polanka, Marc D.; Bohon, Myles D.

Assessment of a Cost-Effective Multi-Fidelity Conjugate Heat Transfer Approach for Metal Temperature Prediction of DLN Gas Turbine Combustor Liners 对一种成本效益型多保真度共轭传热方法在DLN燃气轮机燃烧室衬套金属温度预测中的评估

Energies 2025, Vol. 18, Page 4877

IF3.2

2025-09-30

OAAI

Gianmarco Lemmi; Stefano Gori; Giovanni Riccio; Antonio Andreini

Effect of H 2 and Jet-A1 fuel split on flame stability and pollutant emissions from low-swirl burner H₂和Jet-A1燃料分配比对低旋流燃烧器火焰稳定性和污染物排放的影响

Proceedings of the Combustion Institute

IF5.2

2025-09-24

OAAI

Samarjeet Singh; Matteo Amerighi; Nicola Scopolini; Antonio Andreini; Stefan R. Harth; Dimosthenis Trimis

Lean Blow-Out analysis for the performance assessment of advanced burner designs operating under CO2-diluted air conditions using a high-fidelity CFD approach CO2稀释空气条件下先进燃烧器设计的熄火分析及其性能评估：采用高保真CFD方法

Applications in Energy and Combustion Science

IF6

2025-08-05

OAAI

Gianmarco Lemmi; Simone Castellani; Roberto Meloni; Sofia Galeotti; Antonio Andreini

Numerical investigation of the NOX emissions of a perfectly premixed NH3-H2 flame at moderate pressure levels

FUEL

IF7.5

2025-04-01

OAAI

Meloni, R.; Valera-Medina, A.; Babazzi, G.; Pucci, E.; Castellani, S.; Andreini, A.

Guest Editorial: Special issue on the Joint Meeting of the Belgian and Italian Sections of the Combustion Institute- Combustion Applications for Sustainable Energy and Mobility 来宾社论: 燃烧研究所比利时和意大利分部联席会议特刊-可持续能源和机动性的燃烧应用

APPLIED THERMAL ENGINEERING

IF6.9

2024-12-01

PREAI

Andreini, Antonio; Besagni, Giorgio; Commodo, Mario; Markides, Christos; Parente, Alessandro; Sorrentino, Giancarlo

The impact of film cooling on the heat release within a rotating detonation combustor 薄膜冷却对旋转爆轰燃烧器内放热的影响

APPLICATIONS IN ENERGY AND COMBUSTION SCIENCE

IF6

2024-12-01

OAAI

Sridhara, Shreyas Ramanagar; Andreini, Antonio; Polanka, Marc D.; Bohon, Myles D.

Experimental characterization of an industrial burner operated with simulated EGR

APPLIED THERMAL ENGINEERING

IF6.9

2024-06-01

OAAI

Galeotti, S.; Picchi, A.; Becchi, R.; Meloni, R.; Babazzi, G.; Romano, C.; Andreini, A.

LES investigation of a swirl stabilized technically premixed hydrogen flame with FGM and TFM models

APPLIED THERMAL ENGINEERING

IF6.9

2024-06-01

OAAI

Amerighi, M.; Andreini, A.; Reichel, T.; Tanneberger, T.; Paschereit, C. O.

Characterization of refill region and mixing state immediately ahead of a hydrogen-air rotating detonation using LES 使用LES在氢-空气旋转爆炸之前立即表征再填充区域和混合状态

COMBUSTION AND FLAME

IF6.2

2023-12-01

OAAI

Nassini, Pier Carlo; Andreini, Antonio; Bohon, Myles D.

High-fidelity H2-CH4 jet in crossflow modelling with a flame index-controlled artificially thickened flame model 使用火焰指数控制的人工加厚火焰模型进行横流建模中的高保真H2-CH4射流

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY

IF8.3

2023-11-01

OAAI

Castellani, Simone; Meloni, Roberto; Orsino, Stefano; Ansari, Naseem; Yadav, Rakesh; Bessette, Didier; Boxx, Isaac; Andreini, Antonio

Swirling main flow effects on film cooling: Time resolved adiabatic effectiveness measurements in a gas turbine combustor model

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER

IF5.8

2023-01-01

PREAI

Lenzi, T.; Picchi, A.; Becchi, R.; Andreini, A.; Facchini, B.

Model development for the simulation of the hydrogen addition effect onto the NOx emission of an industrial combustor

FUEL

IF7.5

2022-11-01

PREAI

Meloni, R.; Nassini, P. C.; Andreini, A.

An attempt to predict spray characteristics at early stage of the atomization process by using surface density and curvature distribution

INTERNATIONAL JOURNAL OF MULTIPHASE FLOW

IF3.8

2022-02-01

OAAI

Palanti, L.; Puggelli, S.; Langone, L.; Andreini, A.; Reveillon, J.; Duret, B.; Demoulin, F. X.

研究方向