Large dynamic range nanopositioning using iterative learning control

Gaurav Parmar

doi:10.1016/j.precisioneng.2013.07.003

Return

Large dynamic range nanopositioning using iterative learning control

2014-01-01

PRE

Gaurav Parmar *

Kira Barton

Shorya Awtar

DOI：10.1016/j.precisioneng.2013.07.003

Original

Original request for help

Save

Abstract

En 中文

This paper presents the control system design and tracking performance for a large range single-axis nanopositioning system that is based on a moving magnet actuator and a flexure bearing. While the physical system is designed to be free of friction and backlash, the nonlinearities in the electromagnetic actuator as well as the harmonic distortion in the drive amplifier degrade the tracking performance for dynamic commands. It is shown that linear feedback and feedforward proves to be inadequate to overcome these nonlinearities. This is due to the low open-loop bandwidth of the physical system, which limits the achievable closed-loop bandwidth given actuator saturation concerns. For periodic commands, like those used in scanning applications, the component of the tracking error due to the system nonlinearities exhibits a deterministic pattern and repeats every period. Therefore, a phase lead type iterative learning controller (ILC) is designed and implemented in conjunction with linear feedback and feedforward to reduce this periodic tracking error by more than two orders of magnitude. Experimental results demonstrate the effectiveness of ILC in achieving 10 nm RMS tracking error over 8 mm motion range in response to a 2 Hz band-limited triangular command. This corresponds to a dynamic range of more than 105 for speeds up to 32 mm/s, one of the highest reported in the literature so far, for a cost-effective desktop-sized single-axis motion system. Published by Elsevier Inc.

Keywords:

Large range nanopositioning

Iterative learning control

Dynamic range

Precision motion control